Review: The Partisan Disruptor FRT Trigger

After reading a little about the Partisan Disruptor FRT, I decided that I would get one and test it out in order to decide if I wanted to add them to the inventory and sell them. Well, they are in stock! Yep, they work as advertised. It is a simple install, just pull out your existing trigger, drop it in, tighten the anti-walk pins that are provided, pull the cocking handle back as you close the upper and insert the pin. Done. The functionality of the trigger is solid with crisp clicks into place and a good feeling trigger pull on semi-auto.

The Partisan is well made from quality tool steel. If you are putting it into a gun with a barrel shorter than 16 inches, it will benefit from using an Odin Works H3 buffer. I installed this buffer and it works flawlessly with my PSA 8.5″ Blackout and with my PSA 16″ 5.56 upper. Also a good thing to have is an adjustable gas block to fine tune the performance of the gun. I have an adjustable block on my 8.5 to run with subs. The 16″ upper ran like a champ with a standard gas block. Short video here: .https://rumble.com/shorts/v7gx588 I shot semi and some controlled bursts and dumped a few mags without any hiccups.